smartcel Diamond

smartcel Diamond 
Application The smartcel filament enriched with diamond powder is suitable for
polishing the hardest materials. Depending on the requirements,
different grain sizes and diamond contents are used.
Features

smartcel Diamond contains diamond grain homogeneously distributed
thereby rendering conventional diamond suspensions unnecessary.
High temperature resistance allows working at high speeds.
Natural smartcel filaments do not melt or smudge, even at higher
temperatures. The abrasive particles are fully effective, even under
low contact pressure.

Temperature Resistance Up to 160°, no melting or smudging
Water Absorption Up to 60%
Dimensional Tolerances +/- 10%
Storage Avoid direct exposure to sunlight. Dry
storage at 20°, at a humidity of
40 – 60%.
Resistance Good resistance towards non-polar
solvents such as oil, gasoline,
acetone and benzene and towards
acids and alkaline solutions in the
ph-range of 5 to 8.
Density 1.54 g/cm³
Environment bio-degradable
Impact The high diamond content and the micro-structured, rough particle
surface maximizes the amount of contact points between diamond
particle and workpiece and thus increases the material removal
performance. A small addition of smartpolishoil enhances the impact
of the filaments. A minimal heat build-up and a reduced dirt accumulation
are further advantages.
Dimensions 0.06 – 0.70 mm
Standard color: orange
Special colors: possible. Variations are unavoidable due to refractions
of the diamond.
Grain size: see reverse side
Delivery Form Hank, approximately 1050 mm
Operating Instructions Operate in a dry working environment. Possible addition of small
amounts of oil. Do not use emulsions or water cooling. Operate with
contact pressure as low as possible.
Processing Instructions Bending the filaments excessively may cause them to break.

 

smartcel Diamond